Replant System Catalog

C l i n i c a l a n d L a b o r a t o r y P ro c e d u re s f o r C o n t o u re d A b u t m e n t s Orienting the 15º Angled Abutment The flat side of the Fixture Mount/Transfer [Fig. 1] and the angle of the 15° abutment [Fig. 2] are manufactured to align with the flat of the implant’s internal tri-lobe. Fig. 1 Fixture Mount/Transfer Fig. 2 The two-piece, 15º Angled Abutment consists of an angled body and a fixation screw To establish the optimum angle of the abutment, index the flat surface of the Fixture Mount/Transfer either toward or away from the desired direction of abutment angle at the time of implant placement. Option 1 :- Attaching an Angled Abutment and chairside procedures for preparation Remove the Healing Collar with a 1.25mmD Hex Tool Attach the abutment with the 1.25mmD Hex Tool Mark the required modifications to achieve appropriate clearance Detach the abutment with the 1.25mmD Hex Tool Attach the abutment to the corresponding Implant Analog Reduce the abutment to achieve appropriate clearance Option 2 :- Stage-One transfer followed by laboratory procedures for abutment preparation and provisionalization During implant placement, index the flat of the Fixture-Mount Block out the top of the Fixture-Mount and make a conventional transfer impression Attach the Cover Screw and submerge implant Attach the FixtureMount to the Implant Analog and seat into the negative of the impression Pour the working cast in dental stone with soft tissue replication material Remove the FixtureMount from the working cast with the 1.25mmD Hex Tool Attach the Angled Abutment to the Implant Analog in the working cast with a 1.25mmD Hex Tool Modify angle of abutment and refine margins as required Fabricate the temporary crown At Stage-2 Surgery, Attach the prepared abutment, tighten to 30 Ncm with a Torque Wrench Occlude screw access hole and confirm contour of restoration Cement the provisional restoration Common procedures for abutment placement, margin finessing, impressing and placement of restoration Tighten to 30 Ncm with a Torque Wrench Finesse the margins with a highspeed bur and copious irrigation prior to final impressing Make an impression following standard clinical procedures Attach provisional restoration and cement onto the prepared abutment Follow standard laboratory procedures, fabricate the final restoration and cement onto the prepared abutment 18

Table of Contents Feed for the Digital Edition of Replant System Catalog

For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.