Replant System Catalog

Implant Design & Surface Mini-threads with Double-lead Threads for Faster Insertion The body of the RePlus and ReActive implants are tapered evenly from the top to facilitate insertion into an undersized socket in soft bone providing compression that increases initial stability (G. Niznick: Clinical Oral Health 2000 “Achieving Success in Soft Bone”). The RePlant Implant is designed with a straight / tapered profile matching that of the Replace Implant (Nobel Biocare†). Mini-threads start 1.0mm below the crest of the bone and extend approximately 2.0mm before transitioning into double-lead threads to the apex of the implant. The Mini-threads, half the depth and pitch of the doublelead body threads, reduce stress in the critical crestal bone region, while double-lead threads reduce the number of turns required to seat the implant. Vertical cutting grooves extend halfway up the implant from the apex for self-tapping insertion. All three implants are available with SBM textured surface over the entire implant with HA being an option for the RePlus. Standard “V” Thread Standard “V” Thread All three Implant Direct Tri-lobe implants have Mini-threads for reduced stress near the crest of bone, and double-lead threads on the body for 2X faster insertion The 1.5 taper to the OD of the RePlus and ReActive Implants facilitate bone expansion for increased stability. o Buttress Thread Quadruple Lead MiniThreads 0.3mm 0.6mm 0.45mm 0.85mm Double Lead Threads 1.5 Deg. OD Taper 1.5 Deg. OD Taper RePlant Implant duplicates body design of NobelReplace Implant 1.5 Deg. ID Taper 3.0 Deg. ID Taper 1.5 Deg. OD Taper RePlus Implant threads provide the same 1.5o taper to the inside (ID) and outside thread diameters for optimum soft bone compression ReActive Implant provides more thread engagement by tapering the inside thread diameter (ID) at 3o while the outside thread diameter (OD) tapers at 1.5o SBM and HA Coated Surface Options SBM surface is created by using a Soluble Blast Media of Hydroxylapatite (HA) crystals to create a medium-rough texture. Implant Direct uses the same vendor for its SBM and HA coated surface treatments as used by Paragon Implant Company from 1992-2000 when these studies were conducted. SEM's of Implant Direct’s Surfaces Mini-threads textured by blasting with SBM™: Blasted with Soluble HA Particles HA Coating: High Crystalline 40u layer Only RePlus Implants have an HA option. SBM Surface 20X SBM Surface 50X Animal Studies Bone Response to SBM Surface HA Surface 20X HA Surface 50X 2

Table of Contents Feed for the Digital Edition of Replant System Catalog

For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.