Dental Lab Products - December 2008 - (Page 62) FEATUREDBRANDS Special Advertising Section ZAHN DENTAL CO. INC. 135 Duryea Rd. Melville, NY 11747 800-496-9500 www.zahndental.com www.zahndental.com Rely on us for restorative solutions, CMC Dental Wings and Katana, Pentron Ceramics, and Noritake Ceramics exclusively from Zahn Dental. LAYER OR PRESS Single copings or multi-unit bridge frameworks milled from the nine colored Noritake Katana zirconia milling blocks can be layered with Noritake CZR porcelain or, using press technology, pressed, stained, and glazed. CZR Press technology consists of the marriage of two time-proven technologies: oxide ceramics and pressable ceramics. This synergy combines the strength, fracture toughness, and cementability of pure zirconium oxide copings with the marginal integrity, versatility, and beauty of pressable ceramics. Restoration by Hiro Tokutomi, RDT, Cusp Dental Research, Malden, Mass.; Dentistry by Dr. Markus B. Blatz, Philadelphia. IMPLANT PLANNING VERSATILE ESTHETICS Pentron Ceramics Avante Micro Crystal The Avante® line of porcelain and pressable ceramics is one of dentistry’s most diverse ceramic systems, using the same veneering powder for PFM, pressable all-ceramic, zirconia, or metal-reinforced-pressed techniques. The newest entry to the line is Pentron Ceramics Press·tige ultra-thin (0.3 mm) no-prep/minimal prep pressable veneer. Designed to create a new cosmetic profit center for laboratories, Press·tige exhibits high strength (165 MPa) and exceptional esthetics. HENRY SCHEIN MAXIMA RADIOPAQUE TEETH Avante Press·tige » Ultra-thin (0.3-inch), high-strength (165 MPa) veneers Indicated for no-prep or minimal-prep treatment Designed to create new cosmetic profit center Minimally invasive alternative for patients » » » Maxima Radiopaque teeth offer a solution for determining the placement, location, and angulations of an implant, all the diagnostic steps needed for implant planning the placement. Available in four Upper and three Lower Anterior molds and two Upper and Lower Posterior molds, they come as a set or in a Kit of all molds plus powder. They are made with the same high quality as our Maxima tooth line. Few are as versatile. Value-added services Low-rate competitive financing for any business need, financial planning and consulting, online ordering, equipment repair, laboratory and/or office design, office automation, and technology solutions are but a few of the value-added services Zahn Dental offers customers. 62 BUYERSGUIDE2009 dentallabproducts http://www.zahndental.com http://www.zahndental.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.