Appliance Design - September 2007 - (Page 65) DECORATION Sampling of informational and warning labels. of the safety label. In order to identify any potential hazards associated with a product, the manufacturer should use some type of hazard analysis or an actual physical review of the product. This will not only help determine the actual hazard, but will also give guidance on how to avoid the hazard, and the potential consequences of not avoiding the hazard. Once this step is completed, the severity of the hazard can be determined. Both ANSI and ISO (ISO 3864-2) use the following to define the severity of hazards: 4CAUTION: minor or moderate injury may occur (ANSI). 4CAUTION: minor or moderate injury could occur (ISO). 4WARNING: death or serious injury could occur. 4DANGER: death or serious injury will occur. Once the hazard has been identified and severity has been defined, the actual design process of the safety label can begin. Label design There are several elements that must go into ANSI- and ISO-compliant safety labels, including the pictorials to be used, as well as the verbiage outlining the hazard, hazard avoidance, and consequences. Pictorials: Pictures are considered the uni- versal language when it comes to communicating with everyone, no matter their native tongue or literacy level. Wherever possible, manufacturers should try to use pictorials COST EFFECTIVE CONTROL SOLUTIONS LIQUID LEVEL CONTROLS • • 24 VAC Dual Or Single Probe • Conductance Sensing Pump Up Or Pump Down 120/240 VAC FEATURES • • • • • • • • 24 VAC Operation 50/60 Hz Selectable Sensitivity To 100K ohms Probe Currents Less Than 1 mA 10A Relay @ 240 VAC Resistive 120 Or 240 VAC Operation 50/60 Hz 10,000,000 Mechanical Operations 100,000 Full Load Operations Operating Temperature to 85º C ADAPTIVE DEFROST CONTROL WITH SYSTEM DIAGNOSTICS The Capable Adaptive Defrost Control not only replaces, but offers an advanced approach to the conventional electro-mechanical timer devices as well as currently used adaptive defrost units. CAPABLE ADAPTIVE DEFROST CONTROL FEATURES Cool Mode—Thermostat cycles the compressor through the ADC board. Defrost Mode-The ADC board initiates defrosting based on the adaptive control method.. Diagnostic Mode—LED indicates control diagnosed fault such as: • • Defrost Overload Failure Compressor Does Not Run • • Compressor Runs Continuously Defrost Operation Failure • • Non-volatile fault indication Defrost Bi-Metal Failure To Close CAPABLE CONTROLS, INC. 790 Maple Lane · Bensenville · Illinois 60106 630 860-6514 Capablecontrols.com FAX 630 860-3672 For more Information Enter 143 AD09071Cap1.indd 1 www.applianceDESIGN.com applianceDESIGN 8/13/07 2007 65 September 11:03:40 AM http://Capablecontrols.com http://Capablecontrols.com http://Capablecontrols.com http://www.appliancedesign.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.