Assembly - December 2008 - (Page 61) Profile Combines Channels, Round OD The HX line of robotic end-of-arm framing enables increased flexibility in heavy-duty material handling applications by offering a hybrid profile combining the best of both circular tubing and rectangular frames. Available Dual Cartridge Bench-Top Dispenser • Increases efficiency • Reduces waste • Increases accuracy • Less fatigue on operator • May be used with any pneumatic dispenser 200 ml 400 ml 50 ml Product enhancements • Pinch-valve for positive shutoff • Digital timer for repeatable dispensing Ashby Cross Co. 28 Parker Street, Newburyport, MA 01950 USA ■ (978) 463-0202 ■ FAX (978) 463-0505 in an outside diameter of 40 or 60 millimeters, the HX line allows accessories to be clamped to the diameter or mounted in a channel, thereby facilitating a wide range of configurations. SAS Automation LLC www.sas-automation.com 888-SAS-EOAT www.ashbycross.com Slide Handles Heavy Loads The Narrow Profile Slide 2 is constructed from a single rigid aluminum extrusion profile and is well suited to carrying heavy loads. Available in both single- and dual-carriage configurations, the Narrow Profile Slide 2 is capable of speeds up to 24 ips and is available in lengths up to 107 inches. It can be powered by a stepper or servomotor mounted on the side or in-line. Techno Inc. www.technoautomation.com 800-819-3366 Ergonomic Workplaces and Assembly Lines The recently united Conductix-Wampfler has one critical mission: To offer to manufacturers a comprehensive range of safe, ergonomic overhead energy supply and material handling solutions for assembly lines and work cells. Our customized systems include just the right mix of tool transporters, equipment carriers, jib booms, air hoists, and cable reels to keep your operations up and running. Our rugged, low maintenance products are time-tested in the most demanding environments and backed by a worldwide sales and service network. Contact us today with your system requirements! Electric & Air Supply Systems Goniometer Provides Precision AGC motorized mechanical goniometers can be used in applications where 90 degrees of angular travel is needed with the payload at the center of rotation, or where two axes of rotation are needed about a common point. They can be mounted either to a standard optical Equipment Carriers Tool Transporters Balancers Conductix-Wampfler | 8091 Production Drive | Florence, KY 41042 Tel: (800) 326 2899 | Fax: (859) 814 2110 info.us@conductix.com | www.conductix.com www.assemblymag.com December 2008 / ASSE M B LY 61 http://www.ashbycross.com http://www.sas-automation.com http://www.technoautomation.com http://www.conductix.com http://www.conductix.com http://www.assemblymag.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.