Assembly - February 2009 - (Page 30) Assembly in Action swaged locks between the collar and the bolt would prevent loosening throughout the life span of each collector. The fasteners’ large-diameter heads and flanged collars assured uniform clamp load over a broad contact surface. Operators installed the bolts using 10 HAT electrohydraulic power units and four Avdel 7267 hydro-pneumatic tools. The Avdelok fasteners install in seconds, and the Avdel tools preclude the possibility of operator error, assuring consistent joint integrity with each application. For more on mechanical fasteners, visit www.avdel-global.com or call 704-888-7100. By performing a complete wire-processing audit, Advanced Interconnect Manufacturing was able to improve both quality and machine utilization. Wire-Harness Audit Improves Productivity dvanced Interconnect Manufacturing (AIM—Rochester, NY) produces cable assemblies, wire harness assemblies and electromechanical assemblies A for a wide range of OEMs, including those in the commercial bus, truck, automotive, industrial automation and medical equipment industries. In 2005, the company began a lean manufacturing program to improve both productivity and the quality of its products. Central to this change was a partnership with wire-processing equipment manufacturer Schleuniger Inc. (Manchester, NH), which helped AIM to use its existing equipment Quality Endures. We shipped the first Alpha Series Cam Indexer on September 29, 1997. ZERO replacement cam followers have yet been shipped. FR BH Series Base Machine EE 2-Y WARRANEAR T Y! NEW! Alpha Series Table Indexer GY Series Pick & Place ED Series Shaft Output ServoDex Roller Gear Technology Largest cam follower sizes in the industry with unmatched accuracy. 10655 State Route 47 • PO Box 4338 • Sidney, Ohio 45365 Phone: (937) 498-4901 • sales@sankyoamerica.com www.sankyoamerica.com 30 ASSEMBLY / February 2009 www.assemblymag.com http://www.avdel-global.com http://www.sankyoamerica.com http://www.sankyoamerica.com http://www.assemblymag.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.