Assembly - March 2009 - (Page 22) Advertisement How To Presses 22 Select the Right Electro-Mechanical (Servo) Assembly Press ver the years, press assembly technology has evolved from simple hand-operated presses, which rely on the operator for control, to electro-mechanical presses, which internally control nearly every aspect of the pressing operation. With the advent of the electro-mechanical press (commonly referred to as a servo-press), the level of press control is now virtually unlimited. Electro-mechanical presses can be grouped into three main categories. They range from a basic servo-actuator, used to generate force, to a highly intelligent servo-press system, which provides force/distance feedback and closed-loop force control. To select the best electro-mechanical press for your assembly operation, you need to understand the important differences between the various press categories. Then, by comparing the differences in mechanical design and how the system controls and monitors both position and force during the pressing cycle against your specific needs, you will be able to select the right system. O Basic Servo-Actuator: Consisting of a motor and spindle, a basic servoactuator is generally used to shuttle parts between locations. If properly adapted for pressing, a servo-actuator can be used for uncomplicated pressing operations. Typically, a servo-actuator offers the user the flexibility to control both the ram position and the ram speed while providing closed-loop position control. A servo-actuator can measure force via the torque of the motor or an externally mounted load cell, but it will not provide true closed-loop force control. Available control packages vary by supplier, system builder and required configuration. High-End Servo-Actuator: When designed to function as presses, highend servo-actuators employ several additional mechanical components including planetary roller screw spindles for higher forces, mechanical clutches, integrated load cells and guided antirotational rams. Although software packages, which control and monitor the pressing operation, are available, they do not provide true closedloop force control. Depending on the supplier or builder of the system and required configuration, the unit’s software program will vary greatly in both the degree of press control and the level of monitoring. M A R C H 2 0 0 9 ASSEMBLY • How-To Guide
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.