Pollution Engineering - November 2008 - (Page 51)

Advertorial HOWTO: Bioremediate Chlorinated Solvents without accumulating Metabolites By ADVENTUS GROUP C hlorinated volatile organic compounds (CVOCs) such as tetrachloroethylene (PCE) and trichloroethylene (TCE), commonly used as dry cleaning solvents and degreasers, pose an ongoing threat to human health and wildlife when spilled into groundwater. Through the injection of bioremediation products into the impacted groundwater, the chlorine atoms can be removed from these compounds in situ. However, depending on the treatment pathway, varying amounts of more harmful by-products can be formed, such as cis-dichloroethylene (cis-DCE) and vinyl chloride (VC). Site owners, C&E firms and regulators are realizing that the ability to effectively treat the original contaminants, while minimizing formation of harmful by-products, is an important aspect of performing permanent and responsible in situ bioremediation. The use of simple carbon substrates such as emulsified oils and lactate-based Hydrogen Releasing Compounds often results in the long-term accumulation of these problematic by-products. One method of chemically treating chlorinated solvents without such accumulations is through the use of zero-valent iron. An oxidationreduction reaction occurs where electrons are donated from the ZVI to the solvent, which removes the chlorine atoms from the compound, and in a very short contact time drives the contaminant through to easily biodegraded ethene. Although injecting iron into the subsurface can yield significant degradation of CVOCs, achieving uniform injection of the iron is important and can be difficult to accomplish, as with the injection of any solid or highly viscous liquid. EHC® is a patented combination of solid organic carbon with ZVI that has been field proven to generate very low redox conditions that will drive chlorine from the CVOCs, while minimizing the formation of toxic by-products. The compounds are treated not only via biological mechanisms, but by chemical ones as well. Successful treatment is less dependent on distribution than with ZVI alone. This application of In Situ Chemical Reduction (ISCR) science is extremely reliable in its ability to treat CVOCs in a short timeframe at sites with minimal to negligible accumulation of by-products. The following case study is representative of hundreds of Adventus sites around the globe. Through the Oregon DEQ’s Dry Cleaner Program, remediation of the “Former Serry’s Dry Cleaner” site was conducted through the injection of 10,250 lbs of EHC. The treatment area of 800 ft2 required 32 direct injection locations, implemented by using a pressureactivated GeoProbe® injection tip (Exhibit 1). The injections were performed over a vertical depth of 13 to 25 ft below ground surface (bgs), into a silty clay with fine sand interbeds. Four well clusters Exhibit 1. Pressure-activated injection tip with four side injection ports. 30,000 Concentration [micrograms/L] 25,000 20,000 15,000 10,000 5,000 0 -18 1 5 8 12 14 18 22 24 Time post EHC injections (months) VC DCE TCE PCE Exhibit 2.Influence of EHC injections on CVOC concentrations over time. were sampled over time after the injections, which showed very high removal efficiencies. As shown in Exhibit 2, pre-existing impacts, with PCE as high as 22,000 µg/L, were reduced by 99.9% within 12 months of the injections. Over the short-term, some TCE, cis-DCE and VC were formed, followed by near complete removal between 8 and 12 months. After 2 years, the concentrations have remained at or near non-detect, and monitoring is continuing. For further information on this site, please visit the State Coalition for Remediation of Drycleaners at http://www.deq.state.or.us/wdr/?p=20107, or contact the helpful professionals at Adventus for more details. (888) 295-8661 • info@adventusgroup.com • www. adventusgroup.com HOWTO GUIDE | NOVEMBER2008 www.pollutionengineering.com 51 http://www.deq.state.or.us/wdr/?p=20107 http://www.adventusgroup.com http://www.adventusgroup.com http://www.pollutionengineering.com

Table of Contents Feed for the Digital Edition of Pollution Engineering - November 2008

Pollution Engineering - November 2008 Contents The Editor's Desk EnviroNews PE Events Legal Lookout Casebook Canada Environment Management The Green Files Waste Island Phase I ESAs and Vapor Intrusion Meeting the Mercury Target Wet ESPs - The Sky's the Limit Most Successful IFAT China Ever Thermoplastic to the Rescue Install a Trench Without Open Excavations Remediate Impacted Soils Without Accumulation of Metabolites Apply an Alternative to Wet ESP Solve These Common Pump Problems Minimize Risks Handling Ammonia Monitor International Regulatory Developments for Audits Skim Oil and Save Prevent Chemical Vapor Intrusion Spill Control and Containment Products Pumps and Systems Equipment PE Products Classified Marketplace Advertisers Index State Rules

Pollution Engineering - November 2008

For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.