Conformity Magazine - December 2007 - (Page 27) I n the field of EMC, the two main categories of signals encountered are of particular importance: narrowband signals and broadband signals. The International Electrotechnical Vocabulary (IEV) defines a narrowband disturbance as “an electromagnetic disturbance, or component thereof, which has a bandwidth less than or equal to that of a particular measuring apparatus, receiver or susceptible device.” Consequently, a broadband disturbance is defined as “an electromagnetic disturbance which has a bandwidth greater than that of a particular measuring apparatus, receiver or susceptible device”. This means that the classification of a signal as narrowband or broadband is determined by the occupied frequency spectrum of the signal under investigation, relative to the resolution bandwidth (RBW) of the instrument used for measurement. If the signal spectrum is completely contained in the passband of the IF filter, it is defined as a narrowband signal. The general definition of a narrowband and broadband signal is depicted in Figure 1. It is important to note that continuous wave (CW) signals are a specific case of narrowband signals, since they consist of only one spectral line which is within the passband of the intermediate frequency (IF) filter. This case is depicted in Figure 2 (right). If the occupied signal spectrum exceeds the bandwidth of the filter, the signal is considered to be broadband. This is the case for the spectra of pulses (which are coherent signals) and noise (non-coherent signals). This scenario is shown in Figure 1 (left). This article presents various suggested methods for the determination of signal characteristics in EMC standards and literature. It also discusses their advantages and disadvantages. The presented material builds on previous papers that address the measurement of impulsive signals and discuss test equipment parameters, such as the definition of impulse bandwidth and the purpose of preselection. Therefore, this article will defer to previous publications for details, as necessary. Narrowband and broadband signals can be generated by a variety of sources and usually represent different interference potentials for radio services. Very often, an interference spectrum from equipment under test (EUT) contains both signal types. Since both signal categories require a different interpretation of the result measured with a spectrum analyzer or EMI receiver, it is essential to know the characteristics of a signal in order to correctly determine its frequency and amplitude. In some cases, the characteristics must be known in order to select the correct limit for the determination of EUT compliance. The measurement results displayed on these instruments are also dependent on some control settings, such as the sweep time and resolution bandwidth. Their impact on the measurement of signal parameters, like frequency and pulse width, must be understood to avoid erroneous interpretations of measurement results. Together, we can specify an effective EMI shielding solution for your application. Whether you’re shielding an entire cabinet or a handheld device, Chomerics has the right EMI solution for your application. When you need shielding for telecommunications, avionics, information systems, automotive, consumer, industrial or medical electronics – Chomerics has you covered. Chomerics EMI shielding products include: and compounds manufacturer of EMI shielding solutions – www.chomerics.com 781.939.4850 chomailbox@parker.com DECEMBER 12035_ Chomerics_ Conformity.indd 1 2007 CONFORMITY 27 11/2/07 3:18:54 PM http://www.chomerics.com http://www.chomerics.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.