StandOffs - (Page 10) Security Caps Web Site Link (Parts include everything shown unless otherwise noted) All StandOff Security Caps are available in CLEAR and BLACK anodized finish. Black anodize available at additional cost. 1" StandOffs StandOffs How To: Security Caps Round Caps SO-SC9 5/16" Part SO-SC9 SO-SC3 SO-SC10 1-1/4" Security Caps Diameter 1" 1-1/4" 1-1/2" SO-SC3 Geometric Caps 5/16" 3/32" x 1/4" deep 5/16-18 thread Low Proile Caps SO-SC10 1-1/2" 5/16" Security Caps An HD-SCT is used to tighten Security Caps to prevent unwanted cap removal. 2" 3/32 Barrels Part HD-SCT Security Cap Tool Fits side hole to tighten cap HD-SCT Hubs 1/8" 3/4" 5/32" hex key 9/16" 5/16-18 thread Security Caps replace standard caps on this football trophy case to protect the display. Links & Travelers SO-ASCB Security Cap With Glass or Plastics, use of an HD-NW750 Vinyl Washer is required. Part Fits Materials 1/4" Thick 3/8" Thick 1/2" Thick Grippers 1/8" 3/4" 5/32" hex key Edge Grips SO-ASCB1 SO-ASCB SO-ASCB1 SO-ASCB2 11/16" 5/16-18 thread See HD-AW4 tool for tightening Security Caps are used anywhere our standard caps might be used but can be tightened with the HD-SCT to provide added security when needed. Fixed Hinges 3/4" 1/8" 5/32" hex key HD-PT3 7/16" O.D. SO-ASCB2 13/16" 5/16-18 thread SO 10 NOTE: For Glass or Plastic applications vinyl washers and plastic tube are used to prevent material damage. See Hardware pg. 175 SO 11 http://www.standoffsystems.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.