Miller Edge eCatalog - 6
Model # MGR20 / MGS20
The MGR20 and MGS20 were designed to minimize
installation time while offering customers the three
sided protection for the leading edge of the gate.
These edge sensors simply clip on to the 2" frame.
The rigid base extends beyond the sensitized portion
of the edge sensor to form mounting flanges. To mount,
drill 1/8" holes through the mounting flanges and into
the gate frame every 24 inches. Permanently attach with
#10 screws. Run wire to the gate operator or to wireless
transmitter, and attach to safety reverse terminals per
the gate operator installation manual. Test the edge
sensor and inform the property owner of their obligation to regularly test.
We will replace within one year of shipment from our
factory, any Sensing Edge subject to normal use which
is found to have defective materials or workmanship,
as determined solely by our factory representative.
Replacements will be shipped to you freight collect.
This warranty is void where evidence of misuse or
abuse is present.
Note: For safe operation, use maximum 24 volt AC or
DC power. For detailed instructions, contact Miller
Care of the MGR20 & MGS20. . .
Minimum care is required for the MGR20 and the
MGS20 since they are manufactured with only the
most durable materials and the highest quality control standards. However, Sensing Edges should be
examined regularly for cuts or punctures which
could damage internal components. Check wiring
to be sure connections are secure. When properly
maintained, both the MGR20 and the MGS20 offers
years of trouble free operation.
1 5/8 "
for 2" Square Frames
1 1/4 "
for 2" Round Frames
U.S. Patent #7,282,879.
P.O. Box 159 * West Grove, PA 19390 * (610)869-4422 * Fax: (610)869-4423 * 800-220-3343
6809 South Harl Avenue, Suite A, Tempe, AZ 85283 * (480)755-3565 * Fax (480)755-3558 * 800-887-3343