Mayhew Tools Catalog 2008 - (Page 23) FRONT END TOOLS - PNEUMATIC (.401 SHANK) Shock Absorber Chisel The two-step design of this chisel gives you two cutting edges for easy removal of shock absorber nuts. Idler Arm Bushing Cutter This tool was designed with higher cutting angles to cut the bushing from the idler arm. It also works well as a panel cutter. EDP # 31998 DESCRIPTION 1998 SHOCK ABSORBER CHISEL BOX OF 3 EDP # 31990 DESCRIPTION 1990 IDLER ARM BUSHING CUT BOX OF 3 HEAVY-DUTY PNEUMATIC TOOLS Control Arm Bushing Remover The concave design will hold the contacting edge against the bushing. (.498 SHANK) EDP # 31991 DESCRIPTION 1991 CONTROL ARM BSHG RMVR BOX OF 3 These heavy-duty tools are similar to their counterparts: EDP# 31972, EDP# 31975, EDP# 31981 and EDP# 31997, but they are constructed for heavy-duty use with the .498 Parker Shank. Tie Rod Sleeve Breaker The vibration of this tool against the tie rod assembly will break rust and corrosion to permit easy adjustment. Tapered Punch with 3/16” Point The 3/16” diameter point will drive out pins and rivets. EDP # 31993 DESCRIPTION 1993 TIE ROD SLEEVE BREAKER BOX OF 3 EDP # 31999 DESCRIPTION H-1997 TAPER PUNCH .498 BOX OF 3 Tie Rod Separator The specific opening between tines of 21/32” does the job quickly and properly. 6” Cold Chisel Designed to cut bolts, nuts, tees, angles and frame members.. Blade width is 13/16”. EDP # 31995 DESCRIPTION 1995 TIE ROD SEPARATOR BOX OF 3 EDP # 31989 DESCRIPTION H-1972 COLD CHISEL 6" .498 BOX OF 3 Ball Joint Separator The opening between tines is 15/16”, which will handle ball joints with a minimum of shock to the assembly. Rivet & Bolt Cutter Built with the “beef” and edge to cut rivets and bolts in bumpers, grilles, frames and brackets. Blade width is 13/16”. EDP # BOX OF 3 31992 DESCRIPTION H-1975 RIVET/BOLT CUTTER .498 BOX OF 3 EDP # 31996 DESCRIPTION 1996 BALL JOINT SEPARATOR 1-1/4” Diameter Hammer Taper Punch The 1/8” diameter point will drive out pins and rivets. Excellent for hammering operations such as U-joints, ball joint and body forming work. EDP # 31997 DESCRIPTION 1997 TAPER PUNCH BOX OF 3 EDP # 31994 DESCRIPTION H-1981 HAMMER 1-1/4" DIA .498 BOX OF 3 WARNING: Always wear safety goggles when using hand tools 23
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.