SideXSide Action - March 2008 - (Page 26) Legend Off-Road 3 4 AIr Suspension Install Step Three: Pump mount bracket Step Four: Run air tubing Carefully cut tubing at 90 deg. with sharp blade. To connect hose 5 Note: Make sure to apply blue loc-tite to fasteners prior to installation. A. Bolt air compressor to soleniod bracket using included hardware. B. Remove battery compartment bolts. C. Slide pump mount bracket under the battery compartment. D. Secure pump mount bracket with existing battery compartment stock hardware. Step Five: Wiring the system Tools Needed A. Use provided cable zip ties to route tubing to front and rear shocks staying clear from drive shaft, exhaust system and other potential hazzards. B. Connect tubing to shock and corresponding solenoid. To disconnect hose A. Trace and cut on opening for your contura switches. B. Connect air compressor wires. C. Connect positive and negative wires to the battery. D. Install fuse in fuse holder. 26 SIDE X SIDE ACTION MAGAZINE 17mm 14mm 9/16 10mm 7/32 Utility Knife 10mm For more information about Air Suspension, contact Legend Off-Road Air Suspensions 605.737.4200 or visit the web, www.independentcycleinc.com http://www.independentcycleinc.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.