Chemical Processing - August 2007 - (Page 6) GARLOCK State-of-the-Art Testing Ensures Garlock Valve Packing Exceeds Even the Toughest Standards Environmental compliance is on everyone’s mind, but it’s particularly important to today’s chemical processing facilities. According to the Ecological Society of America (ESA) half of all fugitive emissions come from the hydrocarbon and chemical industries—and valve stem leaks account for 60% of these emissions. That’s why Garlock continues to invest in developing state-of-the-art testing capabilities to ensure our products meet—and even exceed—exacting standards such as API 622 and ISO 15848. Garlock valve packing solutions like 9000 EVSP Simplified™, QUICKSET® 9001, and Style 1303-FEP dramatically reduce your fugitive valve stem emissions. This level of consistent, high-quality sealing brings your operation into compliance with environmental standards—and it can improve your production yields, increase your operating profits, and give you a competitive advantage. More efficient operations also ensure a more productive, safer workplace. And while these solutions produce less than 100 ppm of leakage today, Garlock’s R&D is aiming for single-digits tomorrow! For more information on Garlock’s environmentally focused product advancements, visit www.garlock.com 9000 EVSP 1303-FEP GARLOCK Reduce Cold Flow—and Increase Cash Flow —with Blue GYLON® Style 3504 In chemical processing, cold flow can seriously affect cash flow. When you specify a gasket that’s engineered to reduce cold flow and creep relaxation, you can minimize your operational expenses. Garlock’s unique manufacturing process for Blue GYLON Style 3504 ensures longer gasket life and minimal cold flow problems—problems that you normally experience with skived and expanded PTFE gaskets. In fact, one North American chemical plant realized an $81,600 annual profit improvement simply by converting to Blue GYLON Style 3504. For documented cost savings through reduced fluid loss, inventory, energy consumption, waste, and maintenance—you need Blue GYLON Style 3504. For more information go to www.garlock.com GARLOCK Garlock MULTI-SWELL™ Successfully Seals Even Difficult Water Heat Exchangers It’s a common problem: your bolted flange joint only allows low bolt torque—so it’s difficult to seal properly. That’s why one heat exchanger manufacturer recently switched to MULTI-SWELL Style 3760. Garlock’s self-loading, self-sealing MULTI-SWELL gaskets are activated by contact with either water or oil—and swell to create gasket load. They’re also twice as compressible as standard fiber gaskets, so they can be cut and installed very easily—and they can conform to less-than-desirable flange conditions and seal immediately with lower loads. The manufacturer installed MULTI-SWELL, which sealed immediately—even with the low bolt torques allowed by the heat exchanger’s flange joint. In fact, MULTI-SWELL™ can be used in any industry in standard ring and full face ANSI flanges, difficult-to-seal cast iron flanges, specialty OEM designs, and non-metallic flanges. For more information, go to www.garlock.com World Headquarters: 1666 Division Street, Palmyra, NY 14522 USA 1.800.448.6688 www.garlock.com http://www.garlock.com http://www.garlock.com http://www.garlock.com http://www.garlock.com http://www.garlock.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.