Article Figure 16. Completed blended wing aircraft with printed force sensors, interconnects and LED indicators. the plane and base of the supports are flush at the same level. This allows for 3 points of contact which prevents the printed drone from rolling or moving in either direction. The printed supports have holes for 1 inch ΒΌ" 20 screws which fix into the AJ printers stage providing a strong support to prevent any movement during AJ deposition. In order to create a smooth AJ printable surface, the entire surface has to be treated to get rid of the hills and valleys from FDM printing. The model was first wet sanded with 440 grit sand paper until surface roughness was significantly reduced. The part was then cleaned Take your career to the next level Advanced composite engineers and technicians are in high demand across all industries. We offer accelerated learning and active training courses in engineering, manufacturing and repair of composites. One 5-day course can provide the applicable skills needed to advance your career. Gain the Abaris Advantage, take the first step here - www.abaris.com +1 (775) 827-6568 SAMPE Journal, Volume 53, No. 4, July/August 2017 * www.abaris.com 55http://www.abaris.com http://www.torrtech.com http://www.abaris.com