Best Practice Guide for Warehouses 2008 - (Page 65) WAREHOUSE Installation and Wiring Details BUILDINGS Bulk HB350DR-B Wiring Diagram & HB350DR-B Sensor Exploded View Rack Lens Options HBL4 Lens for Bulk Storage HBL1 Lens for Rack Storage Storage Installation Notes 1. Mount the HB350DR-B on the end of the luminaire using the HBEM3 extender module. 2. There is initial warm-up period for the occupancy sensor upon initial power-up, or after a lengthy power failure.See installation instructions for additional information. 3. Recommended time delay is factory preset at 10 minutes. 4. Mount the sensor so that the lens is at the same height, or slightly below, the bottom of the fixture so it is not blocked by the fixture housing. Mount all sensor at the same height above the finish floor. 5. Confirm night light / egress lighting requirement with local code officials. 6. Remove photosensor cover. See installation instructions for additional information. Equipment Schedule Catalog No. HB350DR-B HBL1 HBL4 HBAA-1 HBEM3 Qty 1 per luminaire 1 per rack storage sensor 1 per bulk storage sensor as shown 1 per sensor Description Dual relay passive infrared occupancy sensor and power module, 120/277 VAC, with integral photosensor and back box Aisleway lens 360° lens Knuckle adjustment (used in rack areas) Extender module www.wattstopper.com • 800.879.8585 www.wattstopper.com • 800.879.8585 W-WAD2.0 0508 65 http://www.wattstopper.com http://www.wattstopper.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.