Best Practice Guide for Warehouses 2008 - (Page 69) WAREHOUSE Installation Notes BUILDINGS Conference 1. Mount DT-200 in corner and aim at opposing corner to provide a full view of the room but not out the door. 2. Mount DT-200 occupancy sensor at same height as luminaire so that sensor view is not blocked. 3. DT-200 is shipped with a factory preset time delay of 20 minutes, the recommended minimum for conference rooms and with sensitivity setting at maximum. Refer to installation instructions if adjustments are necessary. 4. Connect the Miro scene interface to the sensor and the A/V controller. Configure Miro network using installation instructions for room scene controller and Miro Installation Guide. 5. Configure Miro devices to go to the preset off scene when the space is unoccupied and the preset on scene when occupied. Equipment Schedule Catalog No. DT-200 A/V Controller DRD6 MRH6-G DRD4 MRRC3-G DPP5 DPP1 Qty 1 1 2 1 4 1 1 1 Description Dual technology occupancy sensor, isolated relay, wide angle lens Contact closure for dimming system (Optional) (by controller manufacturer) Miro Wall Mount Room Scene Controller Miro Room Scene Remote Miro Universal Dimmer Miro Room Scene Interface Miro Decorator Wall Plate, 5-gang, (select from four standard finishes) Miro Decorator Wall Plate, 1-gang, (select from four standard finishes) Room 69 www.wattstopper.com • 800.879.8585 www.wattstopper.com •W-CR1.0 0508 800.879.8585 http://www.wattstopper.com http://www.wattstopper.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.