Best Practice Guide for Warehouses 2008 - (Page 73) WAREHOUSE Installation and Wiring Details System Installation Diagram BUILDINGS Lunch Lunch Room Wiring Diagram Room Installation Notes 1. Mount the CX-100 in the corner and aim at opposing corner to provide a full view of the room but not out the door. 2. CX-100 is shipped with a factory preset time delay of 18 minutes, the recommended minimum for lunch rooms and with sensitivity setting at maximum. Refer to installation instructions if adjustments are necessary. 3. Use a minimum of 22 gauge wire for low voltage wiring. See Technical Bulletin TB-124 on Voltage Loss at www. wattstopper.com. 4. CX-100 sensors isolated relay can provide status information to BAS and/or control HVAC loads. Equipment Schedule Catalog No. CX-100 BZ-100E-P AC1 Series SP Series Qty 1 1 2 1 Description Passive infrared occupancy sensor, isolated relay, wide angle lens Power pack,120/277 VAC Wall switch, Pass & Seymour/Legrand, AC1 series, single pole Wall plate, Pass & Seymour/Legrand, SP series, 2-gang www.wattstopper.com • 800.879.8585 www.wattstopper.com •W-LR1.0 0508 800.879.8585 73 http://www.wattstopper.com http://www.wattstopper.com http://www.wattstopper.com http://www.wattstopper.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.