Waytek Catalog - (Page 112) Tapes & Chemicals Wire & Cable ELECTRICAL TAPE PVC Electrical Tape Stock No. 21000 For use on electrical splices to insulate and protect. Conforms easily to irregular surfaces. Resists oil, water and weather. 7 mil thick, 3/4" wide, 60’ long, and suitable for use at no more than 600 Volts and up to 176°F (80°C). Supplied in single rolls, 10 roll sleeves and case quantities. Meets UL requirements. Premium All-Weather PVC Electrical Tape Stock No. 21010 Out performs ordinary electrical tape in all extremes of weather. 8 1/2 mil thick, 3/4" wide, 66' long and suitable for use at a maximum of 600 Volts. Temperature range from 0°F to 185°F (-18°C to 85°C). Supplied in single rolls and 24 rolls per case. Meets UL requirements. Rubber Tape Stock No. 20945 Rubber electrical tape, 3/4" x 22'. Good to 600 volts and 176°F (80°C). 30 mil. Circuit Protection Wiring Accessories Terminals & Connectors Colored Electrical Tape Cable Ties A 7 mil high quality electrical tape available in nine colors. 66 ft. roll, 3/4" wide is suitable for use at no more than 600 Volts and up to 176°F (80°C). Meets UL requirements. Color brown red orange yellow green blue violet gray 3M™ VHB™ Tape 4941 Stock No. 20957 Used for bonding pre-painted metals in truck assembly, bonding and sealing pre-painted control panels/switch gears, and mounting vinyl wiring ducts and conduit channels. 1" x 36 yd roll. UL recognized. Double sided. Stock No. 20911 20912 20913 20914 20915 20916 20917 20918 20919 Clamps & Clips Protection Products white COLD SHRINK TAPE Cold shrink tape is an ideal covering for cable lugs, splices and terminations. The tape "welds" itself chemically and mechanically to form a tough seal against weather and moisture. It can be used in temperatures from -40°F to 212°F (-40°C to 100°C) and wraps on a wide range of sizes, shapes and materials. Stock No. 20970 20971 To apply cold shrink tape: Tapes & Chemicals Wire Markers Width x Length 1 in. x 10 ft. 1 in. x 30 ft. Color Black Black Heat Shrink Products Available in two lengths, both 1" wide. After stripping off interleaving film, stretch tape about three times normal length. Keep it stretched while wrapping. Wrap one inch either side of area to be taped, overlapping each wrap at least one-half tape width. Break tape to end wrap. Typical application. Terms & Conditions/Index Wire Coverings No flame or heat required. Finished job should look like this. The cold shrink tape forms a tough watertight skin. 112 Order On-Line: www.waytekwire.com Call Toll Free 1-800-328-2724 http://www.waytekwire.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.