Waytek Catalog - (Page 58) Wiring Accessories Wire & Cable PUSH-PULL SWITCHES Stock No. 44044 Three position, off-on-both on. Chrome knob. Stem 7/16" diameter by 11/4" long. Three #8 screw contacts. Rated up to 15 amps at 12 volts. Stock No. 44041 Two position, off-on. Chrome knob. Stem 3/8" diameter by 11/4" long. Two #8 screw contacts. Rated up to 25 amps at 6 volts or 15 amps at 12 volts. EXTRA HEAVY DUTY PUSH-PULL SWITCH Stock No. 44015 6 to 28 volts, 75 amps DC maximum. On-off, two screw contacts. Chrome plated knob. Mounting stem 15/32" diameter by 5/8" long. Stock No. 44016 Rubber switch boot for switch 44015. Comes with 18" loom piece. Circuit Protection Wiring Accessories Terminals & Connectors BATTERY DISCONNECT SWITCHES Top Mount- Opens Vertically Stock No. 44090 Top mount battery disconnect opens vertically for easy battery disconnection. Carries 250 amps continuous and a maximum surge of 750 amps. For most voltage systems. Suitable for vehicles, farm machinery and medium-duty trucks. 3” x 4” x 2” high. Switches recommended to mount on negative battery post. Top Mount-Post with Wing Nut Stock No. 44091 This battery disconnect opens vertically and comes with a threaded post and wing nut. This disconnect accommodates a variety of versatile wire leads. 3” x 4” x 21/4” high. Protection Products Clamps & Clips Cable Ties Side Mount-Opens Down Stock No. 44092 Battery disconnect is designed for use on side terminal batteries on cars and trucks. Attaches directly on the battery without additional materials. Carries 250 amps continuous and a maximum surge of 750 amps.. 33/4” x 31/4” x 11/4” high. Remote Mount-In-line Stock No. 44093 In-line disconnect mounts under a hood or in other remote locations. Mount this unit in a well ventilated area, then attach a cable from your battery to the SP-1 and connect another cable from SP-1 to the starter or other power load. Use if mounting space is tight or “hidden” location is needed. 3” x 4” x 2” high. Tapes & Chemicals Wire Markers Heat Shrink Products Stock No. 44033 A non-fused current interrupt disconnect designed for opening the circuit between a battery and the complete electrical load of a battery powered system. 50 volts maximum. 400 amps continuous and maximum surge of 2000 amps based on 20% duty with on times of no more than 5 seconds. Rated to 302°F (150°C). 1/2" stud, stud is brass, tin plated. 8” wide x 4.19” high. WIRE & CABLE PRODUCTS See battery cable on page 6. Terms & Conditions/Index Wire Coverings 58 Order On-Line: www.waytekwire.com Call Toll Free 1-800-328-2724 http://www.waytekwire.com
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.