Waytek Catalog - (Page 59) Wiring Accessories Wire & Cable Terms & Conditions/Index Wire Coverings Heat Shrink Products Tapes & Chemicals Wire Markers Protection Products Clamps & Clips MASTER DISCONNECT SWITCHES Sealed, battery disconnect switches are available in two styles: key operated and lever operated. For 6 through 36 volt and 180 amps continuous or 1,000 amps in-rush. One piece die cast housing is 25/8" in diameter and 41/8" long. Mounting stem is 3/4" in diameter and 25/32" long. Extra Heavy Duty Battery Isolator Switch with Removable Handle Stock No. 44080 Heavy duty panel mounted switch with removable handle. SPST (on-off) for battery circuit only. Maximum load is 2500 amps for 5 seconds at 12 volts DC. 250 amp continuous rating. -13°F to 185°F (-25°C to 85°C) operating temperature. 3 ⁄8" studs, slotted 1⁄4" mounting holes on 4" centers. Includes cover and chain. Key Operated Stock No. 44029 SPST (on-off) for battery circuit only. Does not disconnect alternator or generator. Instruction sheet included. 3/8" stud terminals. Switch includes indexing post to prevent rotation. For master disconnect switches with on-off designation. Polished aluminum with black letters. Stock No. 44032 Face Plate for Lever Operated Switches 44030 & 44031 Stock No. 44034 Face Plate for Key Operated Switch 44029 ORDERING NOTES: Battery Isolator Switch with Detachable Key Stop-key single circuit battery master switch with detachable key. Maximum load is 500 amps Spare Key for 5 seconds at 12 volts DC. Stock No. 44077 100 amp continuous rating. -13°F to 185°F (-25°C to 85°C) operating temperature. Spare Key and Splash Proof Cover available. 1. Order by Stock Number and quantity required. 2. Use the optional face plate for on-off indication. Lever Operated Lever Operated Stock No. 44030 SPST (on-off) for battery circuit only. Does not disconnect alternator or generator. Instruction sheet included. 3/8" stud terminals. Stock No. 44031 DPST (on-off) for battery and alternator or generator circuit. Breaks alternator circuit (maximum of 20 amps) prior to disconnecting battery. Instruction sheet included. 3/8" and #10-32 stud terminals. Waterproof Cover Stock No. 44078 Switch Stock No. 44075 Emergency Stop Switch Stock No. 44037 Heavy duty strike off battery isolator switch. Twist to connect, push to disconnect. Rated up to 250 amps at 24V DC. -13°F to 185°F (-25°C to 85°C) operating temperature. BACK-UP ALARMS BACK-UP ALARM SWITCH Stock No. 48001 97db (Conforms to SAE J994, type C) Stock No. 48002 107db (Conforms to SAE J994, type B) 10 times louder than the 97 db alarm. Back-up alarms are offered in two single sound loudness models to sound an alert when a vehicle is backing up. Solid state design seals against dust, moisture and vibration. Steam cleanable. Multi-voltage good for 12 thru 36 volts, positive or negative ground systems. Voltage spike protected. Low current draw. Meets state, federal and US Army Corp of Engineers requirements. Mounting pad with two .300 diameter holes 3.25" on center, may be mounted horizontally or ver tically. Back-up Alarm Switch No. 48022 Designed for vehicles without an automatic back-up switch circuit. Mount adjacent to reverse switch. Spring loaded lever permits over-travel. Normally off, 8 amps max. 24 Hour FAX: 1-800-858-0319 email: sales @waytekwire.com ® ® 59 Cable Ties Circuit Protection Wiring Accessories Terminals & Connectors
For optimal viewing of this digital publication, please enable JavaScript and then refresh the page. If you would like to try to load the digital publication without using Flash Player detection, please click here.