High Performance Versions - Standard Size Ordering is Easy! See Page D-12. Easy online ordering too! Designed to meet the requirements of ASME B31.3 " normal " fluid service* Temperatures to 750°F (399°C) Pressures to 4200 PSI (290 bar) For your most demanding applications, these SureSite® Indicators feature ANSI flanges and fittings and construction to rigorous ASME standards. You can't specify a better visual level indicator. 1. Mounting Configuration Types To choose the best configuration for your application, focus on the process connections (connections where the liquid typically enters/leaves the SureSite). Type AA Type BA Type CA Type DA Top and Bottom Process Connections Side and Side Process Connections Top and Side Process Connections Side and Bottom Process Connections LEVEL INDICATORS - VISUAL T L = Length of Visual Indication L B C to C Sb C to C = L + 10-1/4˝ (260.4 mm) Flag Material L L L & C to C C to C Typical Lengths† Sa T Sa C to C B Sb C to C = L + 3-3/4˝ (95.2 mm) C to C = L C to C = L + 6-1/2˝ (165.1 mm) Plastic (300°F/148.9°C) or Aluminum (750°F/399°C) Length of Indication (Uninterrupted) Minimum Specific Gravity 240˝ (610 cm) 0.39 † Dimensions vary due to connections, material and specific gravity. 2. Material = Stock Material (Best economy and delivery). Materials Code Housing Float 316L Stainless Steel 316L Stainless Steel 600 psi - 2 Titanium (Ti-6AI-4V) 316L Stainless Steel 600 psi+ 9 PRESSURE PSI (BAR) Select desired material from those tabulated below. Mark the Code Number on your OrderIt! Check List. The pressure/temperature performance parameters are specified in the chart at right. Consult the factory with pressure/temperature requirements that fall outside the parameters shown here. These units are manufactured in Schedule 40, 80 or 160 pipe accordingly. 4200 (290) Consult Factory 4000 (276) 3800 (262) 3600 (248) 3400 (234) 3200 (221) High Performance 3000 (207) 2800 (193) 0 0 -18 100 +38 200 +93 400 500 300 +149 +204 +260 TEMPERATURE 600 +316 700 +371 800 +427 °F °C Note: Additional materials, floats, connections and manufacturing techniques are available to extend lengths and operational capabilities. Please contact Gems if the parameters above do not meet your requirements. *Units requiring ASME certification must be specified at time of request. D-10 Visit www.GemsSensors.com for most current information. Hi Perf SureSite / p1of3 / 19-MAY-16http://www.GemsSensors.com