Marine Fabricator July/August 2019 - 47

HOW TO PATTERN SIMILAR, BUT UNIQUE SIDE-BY-SIDE CUSHIONS
Preparation:
Frame out the individual cushion areas
with 1-inch blue painter's tape (which
comes off easily without sticking after
being in the hot sun). Mark side-by-side
seams and include the top edges for the
back cushions.

Canvax works well as a patterning
material because it is strong, easy to mark,
and it allows you to see through to the
layout grid below. Ensure all pieces are
correctly identified with name, number,
date, notch indicators and Velcro locations.

2 ½ inches from the fiberglass edge
below the windshield.
* Seat cushions: We sewed a 2-inch
width of polyester Velcro tape along
the front leading edge. We use
polyester Velcro tape for marine
applications because it withstands
the elements much better than
nylon tape, even though the cost of
polyester tape is almost double the
price of nylon.
We installed sections of Velstick
(available in 1 by 48 inch lengths)
near the front edge of the fiberglass
seating. We use male Velstick tape
because it withstands the elements
better than female Velstick tape. The
new cushions will ensure secure and
luxurious seating for years to come.

Apply ½-inch double-sided tape over
the 1-inch blue tape, and carefully
place Canvax over the entire area to be
patterned. We use Canvax as a patterning
material because it is strong, easy to mark,
and it allows us to see through to the layout
grid we defined ahead of time for each of
the five cushion seat/back combos. Mark
each area and all references for zippers,
Velcro® tape, etc.

When cleaning up the patterns, make sure:
* All pieces are correctly identified with
name, number, date, etc.
* All adjoining cushions have matching
notch indicators.
* All fronts and backs are correctly
marked for their location.
* All seat patterns have Velcro locations
marked (this will provide accurate
alignment for the Velstick® installation
on the vessel). We traditionally install
2-inch female Velcro to the cushions to
ensure a firm 100 percent contact to
the 1-inch male Velstick on the vessel.
Also, we check that the start and stop of
adjoining cushion Velcro is aligned from
port to starboard.

Quick Release Bimini Hinges
& Fender Hangers

Easily install or remove bimini top or fenders without the need for pins and screws
The hinge snaps into base and stays attached to bimini or fender when separated
Made of marine grade 316 stainless steel
Custom designed hardware available

Terri Madden owns Sand Sea & Air Interiors Inc.
in San Juan, Puerto Rico. www.sandseaair.com

For more information, visit:
www.marinefabricatormag.com
Search "bridge cushions"

Phone: 727.572.9202 Fax: 727.572.7621
Email: info@acconmarine.com
Web: www.acconmarine.com
www.marinefabricatormag.com | 47
http://www.acconmarine.com http://www.sandseaair.com http://www.marinefabricatormag.com http://www.marinefabricatormag.com
Marine Fabricator July/August 2019

Table of Contents for the Digital Edition of Marine Fabricator July/August 2019
