PASS & SEYMOUR / INDUSTRIAL PRODUCTS FLEXCOR® REFERENCE Product Split Support Grip Lace & Rod Mesh Termination Split Lace/Split Rod Attachments (for use where end of cable is not accessible) Split Lace Support Grip Mesh Termination For Split Lace mesh termination, Flexcor® single weave Split Lace grips are provided with an additional single lace, two laces are provided with each double weave Split Lace grip. Lace strands should be same material as the grip. 1. Wrap split mesh grip around cable. Start lacing at top or bottom end of mesh. Thread lace through first two loops of split mesh and pull through until the lace is centered at this point. Lace as you would your shoe, crossing laces before lacing the next two loops. 2. Leave a space between adjoining loops approximately equal to the width of one diamond of the mesh. 3. Twist ends of lace strands together at end of grip or tie in a knot. 4. Wrap ends of lace tightly around grip. Excess lace may be cut off. 1 2 3 4 Split Rod Support Grip Mesh Termination 1 For Split Rod mesh termination, a weaving rod is supplied with each grip. The open mesh passes around the rod and matches up with the open mesh from the opposite direction. Split Rod support grips are quick and easy to use and reusable. 1. Wrap split mesh grip around cable. Thread rod through the open loops in a weaving motion, using end of the rod to engage loops. 2. A steady push and twist motion is required. Use other hand to bring mesh loops together so as to weave through them. 3. To remove, pull rod out. 3 2 Most Flexcor products have UL and/or CSA Approvals. Please contact factory for approval information. 334 WWW.LEGRAND.US/PASSANDSEYMOUR INDUSTRIAL PRODUCTShttp://WWW.LEGRAND.US/PASSANDSEYMOUR