14.3 INSTALLATION OF 7.0 RTL / 4.5 RTL GRIPWALK 14.3 - 5 INSTALLING THE HEEL: * Place the heel with the pre - installed screws onto the ski. * Tighten the screws lightly, then firmly. (14.3 - 5) * Check if all screws are tightened firmly. ADJUST THE CODE ON THE BINDING: (see 14.1) REMARK: The easiest way to adjust the heel is moving it with open soleholder. * Pull the locking lever upward (A) and move the heel until the indicator on the side of the heel housing is aligned with the determined code. (14.3 - 6) 14.3 - 6 * Close the locking lever to secure heel position. B CAUTION ! Ensure that the lever is engaged properly ! (14.3 - 7) A CHECK FORWARD PRESSURE: 14.3 - 7 * Place the ski boot into the binding, close the binding. * Correct forward pressure: With the boot in the system the groove on the locking lever has to point to the embossed section of the heel housing (14.3 - 8). If the forward pressure is incorrect: remove the ski boot, lift the lever and move the heel until the forward pressure is correct. RELEASE VALUE SELECTION AND ADJUSTMENT: * Following the correct adjustment for sole length and forward pressure, the release value has to be selected and adjusted. Use the weight method to match the individual skier's needs. See RELEASE VALUE SELECTION AND ADJUSTMENT: 12.1 - 12.3 REMARK: ADJUSTMENT OF DEMO BINDING MODELS: also refer to chapter 14.5 143 - 8 CAUTION ! The release value selection and adjustment has to be done very accurately to care for the skier´s safety. All key information including the release value must be recorded in the workorder. 15.3 98 14.3 MARKER RENTAL & DEMO MODELS