16.3 INSTALLATION OF MARKER KINGPIN DEMO BINDINGS 16.3 - 16 * Correct forward pressure: Check if the forward pressure adjustment screw is flush with the back of the heel housing. If this adjustment is incorrect, turn the screw until it is flush with the back of the housing. (16.3 - 16 and 16.3 - 17) 16.3 - 17 * Remove the ski boot, then re - insert it into the binding and recheck the adjustment. 16.3 - 18 IMPORTANT SAFETY ADVICE ! Make sure that you do not exceed the »STOP« marking on the plate when adjusting the sole length backward ! (16.3 - 18) CAUTION ! After altering the binding, visually inspect the spacing between the boot sole and the change-over lever: the sole may not touch the lever after stepping in ! (16.3 - 19 and 16.3 - 20) 16.3 - 19 INFORMATION FOR BINDING ADJUSTMENT: see chapter 16.4 16.3 - 20 CAUTION ! MARKER KINGPIN DEMO ski bindings do not meet ISO Certification. The product meets the current technical requirements using the latest technology. 123 16.3 INSTALLATION OF MARKER KINGPIN DEMO BINDINGS