16.5 MARKER KINGPIN REPLACING BRAKES / INSTALLATION OF GLIDING AFD 16.5 - 7 CAUTION ! Sliding the ski brake backward, make sure that the hooks of the brake base latch beneath the metal base plate and the plastic base plate of the heel on both sides ! (16.5 - 7) * Install the attachment screws and tighten them by hand. (16.5 - 8) 16.5 - 8 INSTALLATION OF THE KINGPIN GLIDING AFD: The brakes of the KINGPIN bindings can be replaced by the AFD gliding platform. CAUTION ! When using the binding MARKER KINGPIN without brake a safety leash must be installed ! * Remove the brake as described under 16.3 - 1, 16.5 - 2 and 16.5 - 3. * Mount the gliding AFD from top to the heel plate, ensure that the screw points align with the drilled holes. (16.5 - 9) * Install the attachment screws and tighten them by hand. (16.5 - 10) 16.5 - 9 IMPORTANT SAFETY ADVICE ! The MARKER KINGPIN must be equipped with ski brake and / or safety leash ! In case of disregard the ski can speed downhill after a release and hazard other persons. REMARK: MARKER offers a special Kingpin & Alpinist safety leash. (16.5 - 11) Art. #: L002S1A 16.5 - 10 ATTACHING THE SAFETY LEASH: * Pass the leash through one of the holes at the front of the toe and secure the leash with a cow-hitch. (16.5 - 12) 16.5 - 11 16.5 - 12 127 16.5 MARKER KINGPIN REPLACING BRAKES / GLIDING AFD