16.6 MARKER KINGPIN - INFORMATION FOR THE SKIER 16.6 - 1 In addition to the Skier Instruction 15.4, the following instructions must be given to the intended user of a MARKER KINGPIN binding: CHANGE - OVER FROM SKIING TO HIKING POSITION: * Open the heel piece to disengage the boot heel from the binding * Lift and Rotate 180° ski/walk lever located between the toe and heel from SKI to WALK allowing the heelpiece to move back (16.6-1, 16.6-2 and 16.6-3) 16.6- 2 180 ° * With the boot toe engaged with the toe piece of the binding lift up on the toe lever to the (WALK) position. (16.6-4) There will be noticeable clicks into a catch while lifting up on the lever and should be pulled up as far as possible. 16.6 - 3 16.6 - 4 16.6 - 5 II I * Stepping back down firmly with the boot heel the heel piece will close behind the boot heel and the brake will lock down, now being enabled to climb at the 0° walking position. USING THE HIKING AID * In hiking mode, you can use two hiking aids with different angles. (16.6 - 5) 16.6 - 6 HIKING AID LOW POSITION: * To use this position, fold down hiking aid 1 with the pole disc or by brushing along the heel opening lever with the tip of the pole. (16.6 - 6) 16.6- 7 HIKING AID HIGH POSITION: * To use this position, fold down the hiking aid 2 with the pole disc or by brushing along the heel opening lever with the tip of the pole . (16.6 - 7) HIKING AID BASIC POSITION: * Fold the hiking aids back into the starting position individually or together with the pole disc, or by brushing along the heel opening lever with the tip of the pole. 129 16.6 MARKER KINGPIN - INFORMATION FOR THE SKIER