16.8 DIN ADAPTER AT BOOT 16.8 - 5 * Mount the Marker DIN Adapter on the heel. While doing so, check that there is no gap between the edge of the boot heel and the DIN adapter (16.8 - 5 and 16.8 - 6). If applicable, hit the center of the DIN Adapter with a rubber mallet. 16.8 - 6 * Use the original screw from your boot to fix the DIN Adapter to the boot. (16.8 - 6) * Drill the appropriate holes at both ends of the DIN Adapter depending on boot model. Drill into these holes that are around 5 mm deep with a 2.0 mm drill bit. (16.8 - 7 and 16.8 - 8) 16.8 - 7 drill bit size 2.0 mm Dynafit TLT 5 + TLT 6 boots Atomic Backland boots 16.8 - 8 16.8 - 9 0.2 Nm * Then tighten the Torx screws supplied using the manual screwdriver with 0.2 Nm. (16.8 - 9 and 16.8 - 10) 133 16.8 DIN ADAPTER AT BOOT