17.4 MARKER ALPINIST & ALPINIST DEMO - INFORMATION FOR THE SKIER 17.4 - 1 The following instructions must be given to the intended user of a MARKER ALPINIST / ALPINIST DEMO binding: NOTE: The total load of 110 kg / 242 lbs for the binding system must not be exceeded. (17.4 - 1) CAUTION: MARKER ALPINIST & ALPINIST DEMO ski bindings do not meet ISO Certification. 17.4 - 2 MARKER ALPINIST ski bindings are compatible with ski boots with tech inserts to the Dynafit specification of 29.09.2009. In addition, some boot manufacturers have developed boots and manufactured their own inserts for their touring ski boots which should be suitable for Pin-Tech bindings. However, Marker cannot guarantee that these inserts will function correctly. STEP IN: * Clear snow, ice and dirt from the sole of the ski boot and the PinTech inserts before stepping into the binding. * If the toe is closed, open it by pressing down the toe opening lever. (17.4 - 2) 17.4 - 3 * Position the tip of the ski boot on the toe's step-in aids and between the Pin-Tech retaining pins on the toe. (17.4 - 3) * Then press the tip of the boot down and step into the toe until the pins are locked fully into position in the insert, the toe opening lever has to snap to the " Ski " position. (17.4 - 4) 17.4 - 4 * Move the locked boot back and forth several times to ensure that boot and binding are securely connected. 17.4 - 5 * Ensure that the heel holder is turned to the travel position, the locking bolts in the heel holder face forward and the hiking aid is pressed backwards.(17.4 - 5) 145 17.4 MARKER ALPINIST & ALPINIST DEMO - INFORMATION FOR THE SKIER