4.3 MARKER DUKE PT - INFORMATION FOR THE SKIER 4.3 - 7 * The brake is engaged by hand by pushing the brake pedal down or by stepping down on the pedal when stepping in (4.3 - 7). 4.3 - 8 USING THE HIKING AID * In ascent mode, the hiking aid can be used. Swivel the hiking aid forwards/upwards into the 10° ascent position with your hand or ski pole (4.3 - 8). 4.3 - 9 CHANGE OVER FROM HIKING TO SKIING POSITION NOTE: When changing over from hiking to skiing mode, the binding must be freed from snow, ice and dirt ! 4.3 - 10 C B A 4.3 - 11 CHANGING THE BRAKE OVER FROM ASCENT TO DESCENT POSITION * To release the brake, swivel the brake locking lever forwards/ downwards (4.3 - 12). NOTE: It is recommended to remove the skins from the ski only after disengaging the brake. 4.3 - 12 DUKE PT CRAMPONS: MARKER offers special crampons for the DUKE PT models: Crampons DUKE PT 105 mm (ski width → 105 mm) Art. Nr.: H006U1R Crampons DUKE PT 125 mm (ski width 105-125 mm) Art. Nr.: H007U1R Installation of the crampons: see 16.5 * When toe " Ski " has been removed, push toe " Ski " from the front onto toe " Walk " . The locking plate must be pressed down completely by hand and closed (4.3 - 10). * Swivel toe " Ski " towards the back until it engages noticeably and the pin locking bolts engage in the toe locking axis. The adjustment lever must snap into the " Ski " position (4.3 - 11). * To step out of toe " Walk " , press down the adjustment lever on the toe with your ski pole, hand or ski boot and slightly lift the tip of the ski boot (4.3 - 9). 29 4.3 MARKER DUKE PT - INFORMATION FOR THE SKIER