5.3 INSTALLATION OF MARKER F 10 TOUR 5.3 - 1 front plate heel plate small MARKER F 10 TOUR: MARKER F 10 TOUR small: 265 mm - 325 mm MARKER F 10 TOUR large: 305 mm - 365 mm heel plate large 5.3 - 2 REMARK: MARKER F 10 TOUR bindings meet ISO 13992 and 9462 and are designed for the following standard boot soles: * Touring ski boots for adults ISO 9523 * Alpine ski boots for adults ISO 5355 * Touring ski boots for adults ISO 9523 with the additional marking " Gripwalk® " DRILLING THE ATTACHMENT HOLES: * Place the MARKER TOUR installation tool W010G1T or W011J1T (5.3 - 1) in the correct position on the ski. Ski tip 5.3 - 3 * Drill 5 holes for the front plate through the front drill bushings. * MARKER TOUR small: Drill 4 holes for the heel plate through the rear silver drill bushings. * MARKER TOUR large: Drill 4 holes for the heel plate through the rear black drill bushings. * Remove the installation tool from the ski. REMARK: See DRILLING INSTRUCTIONS 3.2 INSTALLING THE HEEL PLATE: * Install the MARKER TOUR heel plate with the 4 pre - installed screws. (5.3 - 2) 5.3 - 4 INSTALLING THE TOE: * Open the binding and install the front plate with the 3 pre - installed screws (5.3 - 3 / 5.3 - 4). 38 5.3 INSTALLATION OF MARKER F10 TOUR