5.4 INSTALLATION OF MARKER JESTER PRO ID & JESTER ID & GRIFFON ID 5.4 - 5 max. 4 Nm 5.4 - 6 INSTALLING THE TOE: * Install the front plate with the pre - installed screws in the front holes. Tighten the screws lightly, then firmly (5.4 - 5). * Slide the toe onto the front plate from the rear (5.4 - 6). 5.4 - 7 CAUTION ! Ensure that the toe is fully and uniformly sliding into the front plate attachments and the height adjustment screw is mounted correct to the front plate. (5.4 - 7) 5.4 - 8 * Install the toe with the enclosed screws. Tighten the screws lightly, then firmly (5.4 - 8). AFD HEIGHT ADJUSTMENT * The height of the AFD gliding plate must be adjusted to the height of the boot sole. (5.4 - 9) 5.4 - 9 REMARK: In the original delivery condition the AFD gliding plate is is preset for: Alpine ski boots for adults according to ISO 5355 and Touring boots for adults according to ISO 9523 with the additional marking " Gripwalk® " 5.4 - 10 ISO 5355 ALPINE + * When the gliding AFD is adjusted to the rear / upper position, the height conforms to the ISO 5355 (Alpine boots) and Touring boots for adults according to ISO 9523 with the additional marking " Gripwalk® " (5.4 - 10) 43 5.4 INSTALLATION OF MARKER ROYAL FAMILY BINDINGS