5.5 INSTALLATION OF MARKER SQUIRE 12 TCX & SQUIRE 11 5.5 - 1 REMARK: heel This mounting instruction is valid for the Squire 12 TCX and Squire 11 models. REMARK: toe 5.5 - 2 ( 18.3) The binding models Squire are designed for the following standard boot soles: * Alpine ski boots for adults ISO 5355 * Touring ski boots for adults ISO 9523 with the additional marking " Gripwalk® " DRILLING THE ATTACHMENT HOLES: See ADJUSTMENT OF THE BINDING INSTALLATION TOOLS 3.2 * Place the MARKER universal installation tool W001G1T or W012J1T (5.5 - 1) in the correct position on the ski. SKI TIP 5.5 - 3 * Drill 4 holes for the front plate (toe) through the red marked drill bushings. * Drill 4 holes for the heel plate (heel) through the red marked drill bushings * Remove installation tool from the ski. REMARK: See DRILLING INSTRUCTIONS 3.2 INSTALLING THE HEEL : * Install the heel plate with the 4 pre - installed screws (5.5 - 2). Tighten the screws lightly, then firmly. 5.5 - 4 * Slide the heel onto the heel plate, starting from the front. (5.5 - 3) * Slide the heel back until it stops. CAUTION ! Ensure that the heel is fully and uniformly sliding onto the heel plate. (5.5 - 4) 46 5.5 INSTALLATION OF MARKER ROYAL FAMILY BINDINGS