5.5 INSTALLATION OF MARKER SQUIRE 12 TCX & SQUIRE 11 5.5 - 5 max. 4 Nm 5.5 - 6 CAUTION ! Ensure that the toe is fully and uniformly sliding into the front plate attachments. * Install the toe with the enclosed screws. Tighten the screws lightly, then firmly (5.5 - 7). 5.5 - 7 POSITIONING THE HEEL: * Move the heel backwards by turning the forward pressure adjustment screw. * Place the ski boot into the binding. Move the heel backwards until the position of the heel is approximately right. (5.5 - 8). 5.5 - 8 CHECK FORWARD PRESSURE: * Place the ski boot into the binding and close it. * Check if the forward pressure adjustment screw is flush with the back of the heel housing. (5.5 - 9 & 5.5 - 10) If this adjustment is incorrect, turn the screw until it is flush with the back of the housing. * Remove the ski boot, then re - insert it into the binding and recheck the adjustment. 5.5 - 9 INSTALLING THE TOE: * Install the front plate with the pre - installed screws in the front holes. Tighten the screws lightly, then firmly (5.5 - 5). * Slide the toe onto the front plate from the rear (5.5 - 6). RELEASE VALUE SELECTION AND ADJUSTMENT: * Following the correct adjustment for sole length and forward pressure, the release value has to be selected and adjusted. Use the weight method to match the individual skier's needs. See RELEASE VALUE SELECTION AND ADJUSTMENT: 12.1 - 12.3 5.5 - 10 CAUTION ! The release value selection and adjustment has to be done very accurately to care for the skier´s safety. All key information including the release value must be recorded in the workorder. 15.3 47 5.5 INSTALLATION OF MARKER ROYAL FAMILY BINDINGS