9.3 INSTALLATION OF M2 / ERP GRIPWALK MODELS SOLE LENGTH ADJUSTMENT: 9.3 - 5 * Slide the toe backward and adjust the sole length in accordance with the sole length scale. The screw hole of the toe spacer has to be aligned with the hole of the plate. (9.3 - 5). 9.3 - 6 5.0 ± 0.5 Nm * Tighten the fixing screws by hand with a torque of 5.0 ± 0.5 Nm. (9.3 - 6) * Screw the heel backward to the correct sole length in accordance with the sole length scale. Indicator: left back edge of the heel housing. (9.3 - 7 / 9.3 - 8) 9.3 - 7 CHECK FORWARD PRESSURE: * Place the ski boot into the binding, close the binding. * Check if the forward pressure adjustment screw is flush with the back of the heel housing. (9.3 - 9). If this adjustment is incorrect, turn the screw until it is flush with the back of the housing. * Remove the ski boot, then re - insert it into the binding and recheck the adjustment. 9.3 - 8 RELEASE VALUE SELECTION AND ADJUSTMENT: * Following the correct adjustment for sole length and forward pressure, the release value has to be selected and adjusted. Use the weight method to match the individual skier's needs. See RELEASE VALUE SELECTION AND ADJUSTMENT: 12.1 - 12.3 9.3 - 9 CAUTION ! The release value selection and adjustment has to be done very accurately to care for the skier´s safety. All key information including the release value must be recorded in the workorder. 15.3 72 9.3 INSTALLATION OF MARKER / K 2 SYSTEMS