Load Cells & Readouts TSU Under Pillow Block Load Cells for Live Shaft Rolls MAGPOWR model TSU Load Cells enable you to read and control web tension in your machine by simply bolting the model TSU load cell under your present roll support bearings. Once installed, they accurately measure the tension forces on the machine sensing roll created by the web, and can display and control the web tension through MAGPOWR tension readouts and controls. The model TSU Load Cell is ruggedly constructed with builtin mechanical overload stops in both force directions, and will stand up to mill duty. A full Wheatstone bridge arrangement is incorporated in each load cell for the most accurate means of measuring web tension. Application of the TSU Load Cells is normally in pairs, one under each pillow block bearing which supports the sensing roll. When installed in this manner, the two load cells accurately measure the total force on the entire roll created by tension in the web, and precisely display it on a MAGPOWR tension readout, regardless of web position. MAGPOWR model TSU Load Cells are available in three sizes and seven load ratings with sensing capabilities of 0 to 5,000 lb. All sizes are already drilled and tapped to accept standard pillow block bearings. No additional adapter plates for mounting the pillow block bearings are required. 72 Load Cells & Readouts Features Positive overload stops in both compression and tension modes of operation Rugged industrial construction Four foil strain gauges in a full Wheatstone bridge (same as expensive instrumentation load cells) Corrosion resistant finish on all external parts Simple installation Sensing actual web tension Pre-drilled and tapped mounting holes for pillow block bearings-no additional adapters required