WIREMOLD 1500 SERIES™ OVERFLOOR RACEWAY Ordering Information 500 & 700 Series Raceways Installation Details 6. Cut lengths of cover to fit between fittings. (Cover must be shorter than mating base: 3/8" [9.5mm] shorter for 1500, 9/16" [14.3mm] shorter for 2600.) Snap covers onto base, latching one side under the base bead and striking cover with a rubber mallet. 1. Determine method of feeding raceway with 1517B, 1585 (shown), 2186 or through a junction box or receptacle box (i.e., 1542, 1546B). 2. Determine length of raceway base to first fitting location. Cut base to desired length. 4. Slip fitting tongue over raceway base and fasten fitting base to surface. Repeat steps 2-4 until fitting and raceway bases are installed along entire run. 5. Lay conductors in raceway base using 1500WC or 2600WC Wire Clips to hold conductors in place. Wire and install devices along run. 2600 or 1500 Base 7. When raceway bases are butted, cover must be installed so that it overlaps joint. 8. Remove proper twistouts in fitting cover making sure that mounting holes line up with fitting base. Install cover with screws furnished. 2602 or 1502 Bushing Wire clip OVERFLOOR RACEWAY 3. Mount raceway base to surface using No. 8 flathead fasteners through all mounting holes provided. 121 WWW.LEGRAND.US/WIREMOLDhttp://WWW.LEGRAND.US/WIREMOLD