MARK'S SPRING TOOLS® Stop marring surfaces with a hammer. Use Mark's Spring Tools®. Mark's Spring Tools® are made in the USA with quality hardened steel construction. These tools have a patented ringed, no pinch grip design. They have a striking force of up to 3,500 lbs psi. So no hammer is needed. Tools work in confined areas where a hammer just will not have space to do its job. Cat. # Description 40509 Complete set of spring tools in plastic case Assortment Includes: 40500 Combination 1⁄16" finish nail starter and 1⁄16" nail set 40501 Combination 1⁄32" and 1⁄16" nail set 40502 Combination 3⁄32" and 1⁄8" nail set 40503 40504 40505 40506 40507 40508 Self centering center punch with a 5⁄16" face for mounting hinges, and brackets Self centering center punch with a 7⁄16" face for mounting hinges, and brackets Cold chisel to remove rivets, screws, etc. For mild steel. Do not use on hardened steel Combination prick punch and center punch for wood or mild steel Door hinge pin tool 7⁄8" long x 1⁄8" diameter Door hinge pin tool 11⁄2" long x 5⁄32" diameter MARK'S NAIL STARTER™ Mark's Nail Starter™ Mark's Nail Starter™ is a 53⁄4" long plastic handle with a powerful magnet on one end that magnetically holds a nail, screw, rivet, or staple in a starting position to prevent thumb and finger injuries. This handy tool is especially helpful in situations where the nail is smaller than the fingers that are trying to hold it. Cat. # Description 40999 Mark's Nail Starter™ 17-80 PHONE 1-800-772-2347 FAX 1-800-991-6275http://www.markspp.com http://www.markspp.com